Products / RX-Link
Wireless alarm integration receiver
Link your wireless security.
To your existing alarm.
RX-Link receives OneControl wireless signals and provides relay outputs for an alarm-zone input, armed response radio or other suitable equipment. Choose a receiver with 1, 2 or 3 relay channels.
RX-Link uses a local 433 MHz LoRa wireless link. It is not a Wi-Fi device.
OneControl is available for iPhone on iOS and for Android phones. See how RX-Link fits into the ecosystem →
Free on-site technical support in Gauteng.
A wireless link with a wired relay output.
OneSensor connection
Receive opening and closing information from a paired OneSensor on a gate, garage door or roller shutter.
Pro+ alarm connection
Receive wireless events from MotorGuard Pro+ or FenceGuard Pro+ and signal your existing alarm equipment.
1, 2 or 3 channels
Choose the number of relay channels your installation needs. The installer wires and tests each required output.
Selected by DIP switches
Four output modes.
Real-time output
With OneSensor, the relay follows the sensor’s open or closed state in real time. It stays in the open state while OneSensor is open and returns to the closed state when OneSensor closes.
For a MotorGuard Pro+ or FenceGuard Pro+ alarm, RX-Link’s relay stays on until the alarm on the device is reset.
Timed output
The relay stays on for the period you choose, then switches off automatically.
Latch output
The relay stays on until you switch it off.
Delayed output
The receiver waits for the selected delay before activating the output, allowing a gate-open alarm to ignore normal short openings.
Select RX-Link’s real-time, latch, timed or delayed output using its DIP switches. Your installer chooses and tests the mode and timing for the connected equipment.
OneSensor → RX-Link → alarm
Warn when a gate is left open.
OneSensor detects the gate opening and sends the signal to RX-Link. With delayed output selected, RX-Link activates its relay if the gate stays open beyond the selected delay.
Normal opening
If the gate closes before the delay expires, the delayed alarm is cancelled.
Gate left open
RX-Link’s relay signals the wired alarm-zone input or armed response connection after the delay.
RX-Link settings use DIP switches. MotorGuard and FenceGuard alarm delays are set in the OneControl app.
Technical details
| Configurations | 1, 2 or 3 relay channels |
|---|---|
| Output modes | Real-time, latch, timed and delayed |
| Mode selection | DIP switches |
| Compatible wireless devices | OneSensor, MotorGuard Pro+ and FenceGuard Pro+ |
| Power supply | 12–24 V DC |
| Wireless frequency | 433 MHz LoRa — local wireless link; not Wi-Fi |
| Wireless range | Up to 150 m line of sight; obstructions and installation conditions affect range |
Fit, pair and test.
Your installer connects the relay to the correct input on the existing alarm or radio, pairs the OneControl wireless device and tests the signal on site. The connected alarm and armed response arrangements determine how the signal is handled.
Can I use it with my existing alarm?
RX-Link provides a relay connection to a suitable alarm-zone input. Your installer checks the wiring, zone programming and alarm response.
Does RX-Link use app settings for its output modes?
Its output modes are selected by DIP switches. App delay settings apply to MotorGuard and FenceGuard.
Choose the right setup for your property.
Tell us about your existing equipment. We will help you check compatibility and choose the right OneControl products.
Free on-site technical support in Gauteng.
